AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
L298n motor driver fritzing9/24/2023 The breadboard icon for this part is just fine, but the schematic circuit model that I have shows only 10 pins instead of the 13 pins associated with this motor driver. See FAQ:Where can I find “specific part” for information about looking for existing part files, and information needed to create new parts. 1 I have been search a long time for an upgraded corrected schematic circuit model for this Fritzing part. Either as is, or as a base for something else. I would not try to use that downloaded part with out some serious cleanup first. To figure out where things are supposed to be, and what should be connected together. To do this properly, a datasheet for the part is really needed. What I see does not have labels except on breadboard, and the part validation tool I use has many complaints. Jumper wires (or cable) would run from the board to a header on the pcb instead. Really, this board does not normally need a pcb view. Spacing and position of the pins on the pcb view also look off. I do not see any of that in the part definition though. Like multiple gnd, or +5V connecting to other +5. Wires are not connecting where they are dragged to except in breadboard view.įewer pins in schematic “CAN” be normal, in cases where multiple physical pins are connected together inside the part. My initial testing of a fresh download of that part says it is broken.
0 Comments
Read More
Leave a Reply. |